Comments, Thoughts and randomness that doesn't deserve its own thread

I'l just come over, drink your beer, eat all your Promite and boop you on the back of the head with a rifle butt...then duct tape you up. Should I leave a little space for you to breath and sweat from?

 

FREAK!

 

https://imgur.com/gallery/UaGeO

full vid

 

In Case Of Fire..............

 

My New EDC

 

I'm loving the 30s...

 

Hating this new truck at the moment. I think I’m getting a whole new axle tomorrow after work

 

Damn, hopefully this does the trick.

 

I sure hope so. I needed a hub assembly, that should’ve been it but they totally rigged it so I’m replacing all the seals. The axle is wrecked from this asshole I bought it from driving it around with no bearing for too long.

 

MOS, you better check the rear diff for play and wear........if the PO drove the sh*t out it enough to wreck / enlarge / crack the rear YOKE and the ujoints...he probably did a lot of burnouts and standing take offs. That sh*t is BRUTAL on the rear end and driveshaft components. Your carrier assembly may be worn to sh*t.

seriously, i know this sucks big-time, but while its in for hub assemblies....get them to pull the rear diff cover off and inspect the diff gears..........

 

least its not a diesel jeep liberty though....

 

not legal up here Bro! unless your RCMP, for some reason they are allowed OTF knives. (personally I can open a spyderco folder FASTER than an OTF can fire its blade....but thats none of my business.......)

 

Old People should be recruited......



https://imgur.com/gallery/i6Pob

 

Well I’m the guy so I’ll be checking that when I’m done with the front end. The only thing I’ll pay anyone to do is leaf springs, which is happening this week on it. Thanks for the heads up Bushy

 

Even if I was being serious, that thing would be astronomically expensive.

You'd also be surprised how easy one can get an auto or in my case, a balisong. I no longer have it, so I can admit it publicly

Actually, now that I think about it. I do have a Benchmade 40T Balisong. Perfectly legal tho. As the "t" stands for trainer. But it's a real model 40 Benchmade, just has the blade drilled out so it can't be sharpened.

 

6 arseh*** teenagers pelted my work truck with rotten apples yesterday. dam near broke the windshield.

So i drove Ol Ten Ton tandem axle with a massive inline Cummins diesel, around the block. Its been pouring rain here....there are 1 - 2 foot deep puddles everywhere. I gear jammed that old whore to 100 KM/H and hit that deep puddle beside the teens. I figure about 1000 liters of water soaked and knocked them over. Bus driver behind me was laughing so hard he almost went off the road.

Karma you little as****** pukes.

 

Teaching them life lessons whether they know it or not @Bushman5

 

I'm now the second most unpopular popular guy.

 

What happened to @Slade? Haven't heard from him in a while. I think he moved a few weeks back. Poor bastard probably has a real life.