3hm Hollow Pins

Discussion in 'DIY (Do It Yourself)' started by winternews, Apr 9, 2020.

  1. winternews

    winternews Member

    Messages:
    6
    Likes Received:
    9
    Location:
    Alaska
    I searched the forum but didn't see any results, so here's my question. I'm planning to chop a little off the end of my 3HM handle. For me, the extra length isn't needed. I figured while I'm at it, I'd try replacing the bolts with hollow pins. I've made a good number of kydex sheaths, so I'm familiar with setting eyelets, but does anyone have advice on a good resource for this process? I'm guessing I just have to find some of the proper diameter and sink them in with a little epoxy? Thanks in advance for any advice.
     

Share This Page